How to Paint Silicone Phone Covers

When you paint a silicone cellphone cover, you may spruce up a cheaper, time-honored silicone smartphone cowl or add new life to an old one. Painting silicone telephone covers can be carried out with minimum effort and is much less high-priced than purchasing new phone covers.

Silicone Phone Covers

Saturate a cotton ball with denatured alcohol. Rub the drink throughout the lower back and sides of the silicone telephone cowl. This will help ruin down the silicone so that it may be sanded. Allow the alcohol to dry thoroughly earlier than intending.

Rub the sides and lower back of the silicone phone cover with a fine-grit sandpaper. Work in small sections until the whole outdoor floor location has been sanded. You do no longer need to file the internal of the case.

Wash the silicone smartphone cover with dish cleaning soap and heat water. Make positive to remove all the loose silicone and sandpaper dirt. Dry the case with a paper towel.

Paint the lower back facet of the silicone phone cover with an oil-primarily based primer. Allow the paint to dry, after which paint the edges of the telephone case. Let the primer dry absolutely.

Paint the primed silicone telephone cover with oil paint. Paint the lower back aspect, after which the outside edges. Use at least two coats of paint.

Mark the regions of the container to be reduced with a straightedge and pencil. For a traditional American smartphone booth, get rid of most of all four sides. Leave a panel across the pinnacle for the “smartphone” signal, the corners to attach the bottom to the roof, a strip around the middle on three facets, and a panel around the lowest on three aspects. To create the iconic purple British smartphone sales space, create a grid on all four sides to make divided windows.

Cut out the marked areas with a craft knife. Leave good cardboard on the corners to hold the field standing — you don’t need the supports to buckle. For the American cellphone sales space, get rid of the front panel entirely. For the British telephone booth, cut out the front panel; however, reattach it at one facet with duct tape for a door opening and closing.

Spray paint the field silver or pink. Use a stencil to spray paint the phrase “TELEPHONE” in capital letters on white paper. Use blue paint for the silver American sales space and black color for the purple British booth. Make four signs and symptoms and glue one to each side of the smartphone booth on the card panels you left at the pinnacle.

Spray paint a shoebox black and region a black telephone receiver interior. Tape the quiet of the twine to the internal of the container. Staple the shoebox telephone to one of the strips of cardboard in the booth, or create a brand new region for the cellphone by using slicing a panel of cardboard, spray portray it and duct taping it vertically towards one of the returned corners of the booth, forming a flat floor to staple the shoebox too.

Silicone Phone Covers

The “old-style” approach of using an integrated allure hanger is most straightforward and may be changed for telephones without the sort of hanger. Look for an indentation with a small bar inner it at the telephone’s upper fringe– that is where the allure belongs. The charm usually has a small strap or loop attached; if not, buy a cellphone strap, a narrow circle of solid wire with a bounce ring at the cease. Open the bouncing ring and attach it to the loop on the allure, plenty as you’ll add a key onto a key ring. Squeeze the strap or twine loop flat and push it via the indentation within the phone and out the opposite facet. Pull the appeal via the circle and then pull it tight. The loop is secured across the bar in the allure hanger, and the attraction dangles from the other cease of the twine.

Read Previous

Important Accessories And Apps For Your HTC Phone

Read Next

Dust And White Water – Proof Cases For Your Iphones